Cedar Park Home / Services / Soffit, Fascia and Trim
Soffit, Fascia and Trim in Cedar Park
The boards along and under the roof overhang tie the roof to the walls. On a stone-front house they are often the only painted wood on the street side.
Fascia is the board the gutter hangs on. Soffit is the panel under the overhang. Trim is everything that covers a joint: corner boards, window and door surrounds, and the band where siding meets masonry.
The contractor replaces rotted sections, fixes what was wetting them, and primes, caulks and paints.
What Goes Wrong
- Fascia rot behind the gutter. A clogged gutter overflows backward, or there is no drip edge, and the top of the fascia stays wet. The gutter then pulls loose because its screws are in soft wood.
- Soffit stains and sag. Usually water from the fascia or from a roof leak at the eave. Sometimes animals.
- Blocked soffit vents. Painted over or stuffed with insulation from inside, starving the attic of intake air.
- Open trim joints. Caulk dries and cracks in the sun, and water gets behind corner boards and window heads.
- The band above the stone. Where siding starts on top of masonry there should be a flashing that tips water outward. If it is flat or missing, the bottom edge of the siding and the trim board rot.
Materials
Replacements for original wood trim include primed finger-jointed wood, fiber cement trim boards and PVC. Fiber cement and PVC do not rot. Vented soffit comes in fiber cement, aluminum and vinyl panels. Matching the existing profile matters more on the front of the house than the back.
Ask for every cut end to be primed and for stainless or coated fasteners.
Doing It With Other Work
Fascia is easiest to replace when the gutters are off, and the top edge is easiest to protect when the roof is being replaced and new drip edge is going on. If either of those jobs is coming, do the fascia at the same time.
Related: gutters and roof edge, and attic vents for the intake side.
Questions About Soffit, Fascia and Trim in Cedar Park
Can rotted fascia be patched?
Short sections can be cut out and replaced with a joint over a rafter end. If rot runs along a whole gutter length, replacing that run is cleaner.
Do I need vented soffit everywhere?
No. Vents need to add up to enough intake for the attic and be spread along the eaves. A roofer can work out the amount.
Is trim work something a roofer does?
Many roofing and siding contractors do fascia, soffit and trim because it sits between their two trades. Say on the call that trim is part of the job.
Rot Along the Roof Edge?
A local contractor can replace the boards and stop the water that caused it.
Call (737) 237-8273 Open the Form